Die Suche ergab 487 Treffer

von Commodåren
12.06.2022, 10:31
Forum: Spielwiese
Thema: Lieferwagen OM602
Antworten: 33
Zugriffe: 3735

Re: Lieferwagen OM602

At the Opel meet in Kannus Finland, I saw this: 20220611_124216.jpg A Rekord C Delivery with an Isuzu-built 17DT engine from a Vectra. Fits p & p to the stock column shift four speed with an 18S bellhousing. The 4,22:1 rear gears should probably be swapped to something higher for maximum fuel ef...
von Commodåren
03.06.2022, 03:56
Forum: Spielwiese
Thema: Weber 32/36
Antworten: 29
Zugriffe: 2909

Re: Weber 32/36

No more than 0,2 bar fuel pressure with Weber carbs.
von Commodåren
08.05.2022, 17:15
Forum: Schrauben im Normalbereich
Thema: ET Rekord Felgen
Antworten: 18
Zugriffe: 1879

Re: ET Rekord Felgen

Measure the backspace of your original wheels and compare with the backspace of the new ones.
http://www.wheelspecialists.com/wheel-specs
https://tireswheelsdirect.com/wheel-off ... alculator/
von Commodåren
16.02.2022, 21:22
Forum: Schrauben im Normalbereich
Thema: 1.9S 3 fach und 4 fach gelagerte Nockenwelle
Antworten: 6
Zugriffe: 659

Re: 1.9S 3 fach und 4 fach gelagerte Nockenwelle

Of the standard four bearing Opel cams the D(19SH) and K(20S) are probably best for a 19S.
von Commodåren
16.02.2022, 19:39
Forum: Schrauben im Normalbereich
Thema: 1.9S 3 fach und 4 fach gelagerte Nockenwelle
Antworten: 6
Zugriffe: 659

Re: 1.9S 3 fach und 4 fach gelagerte Nockenwelle

You can use a four bearing cam without problems.
von Commodåren
23.01.2022, 11:38
Forum: Schrauben im Normalbereich
Thema: 1.2 OHV in Rekord A ??
Antworten: 42
Zugriffe: 4386

Re: 1.2 OHV in Rekord A ??

No, the bellhousing is totally different.
von Commodåren
22.08.2021, 13:44
Forum: Schrauben im Normalbereich
Thema: Hinterachse rubbelt, rattert hoppelt
Antworten: 56
Zugriffe: 3709

Re: Hinterachse rubbelt, rattert hoppelt

Try turning the shocks a few clicks stiffer.
von Commodåren
02.07.2021, 18:28
Forum: Schrauben im Normalbereich
Thema: Ausgleichskorb Hinterachse vom Rekord E?
Antworten: 1
Zugriffe: 466

Re: Ausgleichskorb Hinterachse vom Rekord E?

You need to transplant everything inside the 22i axle to your Rekord C axle, except the half shafts. But it must be from a 22i limo, a 22i Caravan has the larger Senator/Monza/Omega type diff. If you are going to use the Getrag 240, you must also shorten your Rekord C drive shaft about 70mm and swap...
von Commodåren
19.06.2021, 17:29
Forum: Schrauben im Normalbereich
Thema: Von Kopf bis…Block
Antworten: 2
Zugriffe: 466

Re: Von Kopf bis…Block

An original 19SH head has four cam bearings and a hydraulic cam. I'm not 100% sure, but I think it should say X19 on the pad on the left side of the cam inspection cover.
von Commodåren
13.06.2021, 19:57
Forum: Spielwiese
Thema: Import aus Schweden zulassen
Antworten: 9
Zugriffe: 1721

Re: Import aus Schweden zulassen

The plate is of the old type that was in use before -72/-73 and the letter Y says that the car was registered in Västernorrlands Län. https://sv.wikipedia.org/wiki/V%C3%A4sternorrlands_l%C3%A4n#/media/Fil:Västernorrland_County.png You could try asking Transportstyrelsen if it is still in the register.
von Commodåren
06.06.2021, 15:43
Forum: Schrauben im Normalbereich
Thema: Didta US Version
Antworten: 4
Zugriffe: 437

Re: Didta US Version

From -71 and up, the engines are of the low compression type due to stricter emission rules. The engines are basicly 19N motors with a two barrel carb instead of a 35PDSI, so a re-jetting of the carb is probably necessary.
von Commodåren
04.05.2021, 21:14
Forum: Spielwiese
Thema: Lieferwagen
Antworten: 10
Zugriffe: 1092

Re: Lieferwagen

Not too hard to find here in Finland, they were popular back in the day because deliverys were tax exempt. But you could only drive max 80km/h though. :)